BURKERT德國進口氣動式二位二通截止閥簡介
如果您對該產品感興趣的話,可以
產品名稱: BURKERT德國進口氣動式二位二通截止閥簡介
產品型號: 438680
產品展商: BURKERT
產品文檔: 無相關文檔
簡單介紹
BURKERT德國進口氣動式二位二通截止閥簡介
?Measured as overpressure to the atmospheric pressure Response times [ms]:
Opening? Closing Measured at valve outlet at 6 bar and +20oC. Pressure relief 0 90% Pressure drop 100 to 10%
cv截止閥又稱截門閥，屬于強制密封式閥門，所以在閥門關閉時，必須向閥瓣施加壓力，以強制密封面不泄漏。，
表示閥門已達全開位置。所以截止閥的全開位置，應由閥瓣的行程來決定。
neutral medium (e.g. compressed air, town gas, water, hydraulic oil) per-solution
BURKERT德國進口氣動式二位二
BURKERT德國進口氣動式二位二通截止閥簡介
的詳細介紹
BURKERT德國進口氣動式二位二通截止閥簡介
上海乾拓貿易有限公司
企業QQ：
電話；021-69001039
手機；17321017802（微信）
郵箱；17321017802@163.com
地址：上海市嘉定區江橋嘉涌路99弄6號樓713
The actuator body is made out of epoxy resin.
主軸設計有雙層密封件，但沒有壓蓋。
緊湊型結構
2/2-way valve for medium up to +140oC
The externally controlled valve is pneumatically operated. It consists of a diaphragm actuator and a 2-way valve body.
驅動裝置外殼由環氧樹脂構成。
主軸設計有雙層密封件，但沒有壓蓋。
in particular air, water, hydraulic liquids up to max.
+90 oC Pilot pressure see diagram Ambient temperature -10 up to +90 oC Installation As required, preferably with actuator upright
Flow rate Kv value water [m3/h]:
我國閥門“三化給”曾規定，截止閥的流向，一律采用自上而下。
截止閥開啟時，閥瓣的開啟*度，為公稱直徑的25%～30%時.流量已達到
measured at +20°C, 1 bar pressure at valve inlet and free outlet Pressure values [bar]
Measured as overpressure to the atmospheric pressure Response times [ms]:
Opening Closing Measured at valve outlet at 6 bar and +20oC. Pressure relief 0 90% Pressure drop 100 to 10%
cv截止閥又稱截門閥，屬于強制密封式閥門，所以在閥門關閉時，必須向閥瓣施加壓力，以強制密封面不泄漏。，
表示閥門已達全開位置。所以截止閥的全開位置，應由閥瓣的行程來決定。
neutral medium (e.g. compressed air, town gas, water, hydraulic oil) per-solution,
oxygen, hot air oil and fat-free medium e.g. hot water,
雙主軸密封件
The diaphragm actuator moves a spindle with valve disc against a spring and switches the valve.
The spindle is designed glandless with double seal.
Technical data Body material Brass, stainless steel Inner part valve Stainless steel
Actuator Epoxy resin Seal material NBR, FKM, PTFE/FKM, EPDM, PTFE/EPDM Medium NBR
驅動裝置外殼由環氧樹脂構成。
無流量時關閉或打開
PTFE/EPDM (PFTE seal with EPDM O-Ring) PTFE/FKM (PTFE seal with FKM O-Ring)
當介質由閥瓣下方進入閥門時，操作力所需要克服的阻力，是閥桿和填料的摩擦力與由介質的壓力所產生的推力，
關閥門的力比開閥門的力大，所以閥桿的直徑要大，否則會發生閥桿頂彎的故障。
to +100 oC -10 up to +100 oC -10 up to +140 oC -10 up to +140 oC Control medium neutral gases and liquids,
in particular air, water, hydraulic liquids up to max.
+90 oC Pilot pressure see diagram Ambient temperature -10 up to +90 oC Installation As required, preferably with actuator upright
Flow rate Kv value water [m3/h]:
measured at +20°C, 1 bar pressure at valve inlet and free outlet Pressure values [bar]
Measured as overpressure to the atmospheric pressure Response times [ms]:
Opening Closing Measured at valve outlet at 6 bar and +20oC. Pressure relief 0 90% Pressure drop 100 to 10%
cv截止閥又稱截門閥，屬于強制密封式閥門，所以在閥門關閉時，必須向閥瓣施加壓力，以強制密封面不泄漏。
alkaline washing and bleaching lyes oil and fat-free medium, e.g. hot water and steam
hot oils, hydrocarbonated water, aromatics and steam
Viscosity max. 100 mm2/s Medium temperature NBR FKM EPDM PTFE/EPDM PTFE/FKM -10 up to + 90 oC -10 up
我國閥門“三化給”曾規定，截止閥的流向，一律采用自上而下。
截止閥開啟時，閥瓣的開啟*度，為公稱直徑的25%～30%時.流量已達到
alkaline washing and bleaching lyes oil and fat-free medium, e.g. hot water and steam
hot oils, hydrocarbonated water, aromatics and steam
Viscosity max. 100 mm2/s Medium temperature NBR FKM EPDM PTFE/EPDM PTFE/FKM -10 up to + 90 oC -10 up
to +100 oC -10 up to +100 oC -10 up to +140 oC -10 up to +140 oC Control medium neutral gases and liquids,
當介質由閥瓣下方進入閥門時，操作力所需要克服的阻力，是閥桿和填料的摩擦力與由介質的壓力所產生的推力，
BURKERT德國進口氣動式二位二通截止閥簡介
